The Henderson–Hasselbalch equation expresses the pH of a solution in terms of the dissociation constant of a weak acid and the ratio of its conjugate base to its undissociated acid form. In its commonly used concentration form,
Here, is the acid, is its conjugate base, and . The equation is central to understanding buffer solutions, acid–base titrations, and the protonation of biological molecules. Its activity-based form is an equilibrium identity; approximations enter when activities are replaced by concentrations or equilibrium concentrations are replaced by quantities calculated from a mixture’s initial composition.
Derivation and thermodynamic meaning
A weak acid undergoes an acid–base reaction with water:
Using the conventional aqueous notation for the hydrated hydrogen ion, the acid dissociation constant is written
where denotes the dimensionless activity of species , with water treated as the solvent in the conventional aqueous definition. Rearranging and taking negative base-10 logarithms gives
This is the thermodynamic form of the Henderson–Hasselbalch equation. It is an algebraic rearrangement of the expression for chemical equilibrium, rather than a separate empirical law.
On a molar concentration scale, activity can be expressed as
where is an activity coefficient and is the standard concentration. Consequently,
The familiar concentration equation neglects the final activity-coefficient term or incorporates its effect into a conditional, medium-specific . This distinction matters because pH is defined through hydrogen-ion activity, not simply hydrogen-ion concentration.
Interpretation
The equation gives a direct relationship between pH and the relative abundance of two conjugate forms:
- When acid and conjugate base have equal activities, .
- A tenfold increase in the base-to-acid activity ratio raises pH by one unit.
- A tenfold decrease in that ratio lowers pH by one unit.
In the concentration approximation, the ratio can be written
For an isolated acid–base pair with total concentration , the fraction present as conjugate base is therefore approximately
Thus, below the acid’s , its protonated form predominates; above it, the deprotonated form predominates. The transition is gradual, not an abrupt switch.
Example
For an acetic acid–acetate mixture, using a dilute-solution of approximately 4.76 at , suppose the equilibrium concentrations are
Neglecting activity corrections,
This is a concentration-based estimate; its accuracy depends on the solution’s nonideality and the appropriateness of the dissociation constant used.
Buffers and titrations
A buffer contains appreciable amounts of a weak acid and its conjugate base. Added acid reacts primarily with the conjugate base, while added strong base consumes the weak acid. These reactions alter the ratio in the Henderson–Hasselbalch equation, but the logarithmic dependence makes the pH change comparatively small while both components remain abundant.
For many simple buffers, a useful working interval is approximately
corresponding to base-to-acid concentration ratios between about and . This is a practical convention, not a strict boundary.
The equation alone does not specify buffer capacity, the amount of added acid or base that produces a given pH change. Two mixtures can have the same component ratio and nearly the same pH but very different capacities because their total concentrations differ. For a simple monoprotic buffer at fixed total concentration, the contribution of the acid–base pair to buffer capacity is greatest near equal acid and base concentrations.
In a titration of a weak acid with a strong base, the equation describes the buffer region before the equivalence point. The amounts of acid remaining and conjugate base formed are first calculated using stoichiometry. Their ratio can then be used to estimate pH. At the half-equivalence point, equal analytical amounts of the two forms usually give
provided equilibrium shifts and activity effects are sufficiently small. At the equivalence point, this simple calculation is unsuitable because essentially all of the initially supplied acid has been neutralized; the conjugate base’s reaction with water must instead be considered.
Weak bases and multiple dissociation steps
For a weak base and its conjugate acid , the same relationship can be written
An equivalent base-centered form is
The connection between pH and pOH is . The often-used value applies near under dilute aqueous conditions; it is not independent of temperature.
A polyprotic acid has several successive dissociation equilibria. Each step has its own Henderson–Hasselbalch relation. For example,
When successive dissociation constants are well separated, individual buffer regions are often distinguishable. When they overlap, several protonation states contribute substantially, and a single two-species approximation does not describe the full composition.
Applications in biochemistry and physiology
In biochemistry, the equation describes the approximate protonation fractions of amino acid side chains, metabolites, and other ionizable groups. These fractions help explain pH-dependent changes in molecular charge, binding, and enzyme activity.
For proteins, however, an ionizable group’s apparent depends on its local environment. Interactions among nearby charged groups and changes in molecular conformation can produce behavior that is not captured by a model of independent, identical acid–base sites.
A physiological application concerns the bicarbonate–carbon dioxide system. A commonly used expression for blood plasma at is
Here, is carbon dioxide partial pressure, and is its solubility coefficient in the relevant medium. When bicarbonate is expressed in and pressure in , a commonly used approximate coefficient is .
The apparent constant near 6.1 refers to a convention that groups dissolved carbon dioxide with the much smaller amount of hydrated carbonic acid. It is not the intrinsic dissociation constant of carbonic acid alone. Unlike a closed laboratory buffer, the physiological system exchanges carbon dioxide through respiration and has bicarbonate regulated through renal processes.
Assumptions and limitations
Equilibrium concentrations versus amounts initially mixed. The equation contains equilibrium activities or concentrations. Substituting preparation concentrations is an additional approximation, justified only when dissociation and other reactions do not substantially change the amounts of the two buffer components.
Dilute or weakly buffered solutions. At very low total buffer concentration, water’s contribution to acid–base balance can become important. An extremely small proportion of one buffer component can also make simple concentration substitutions unreliable. A complete calculation may require mass balances, electrical charge balance, and water’s dissociation equilibrium.
Nonideal solutions. Changes in ionic strength alter activity coefficients. Concentrated solutions, highly charged species, and mixed solvents may therefore require explicit activity corrections or conditional constants measured under matching conditions.
Changing temperature and medium. Dissociation constants depend on temperature and solvent environment. A tabulated is not a universal constant independent of experimental conditions.
Additional reactions. Complex formation, precipitation, gas exchange, and reactions involving other protonation states can change the concentrations of free acid and conjugate base. The equation remains applicable to a correctly specified equilibrium pair, but it does not by itself determine the entire solution composition.
Historical development
Lawrence Joseph Henderson developed a relationship describing hydrogen-ion concentration in bicarbonate buffer systems in 1908. Karl Albert Hasselbalch recast the relationship in logarithmic form in 1916, using the pH notation introduced by Søren P. L. Sørensen in 1909. The combined name reflects Henderson’s equilibrium formulation and Hasselbalch’s logarithmic expression.