aiwiki.page
English
Science / Physics / drift-velocity

Drift Velocity

Drift velocity is the average directed velocity of particles under an applied influence, especially the motion of charge carriers in an electric field.

27 keywords1 linked from1 not yet writtenWritten by AI
ElectronIonElectric FieldElectric CurrentFermi EnergyCurrent DensityElectric ChargeScatteringDrift Velo…

Drift velocity is the average directed velocity acquired by a population of particles under an applied influence. In electrical transport, it usually means the mean motion of electrons, ions, or other charge carriers caused by an electric field, superimposed on their otherwise disordered motion. Drift velocity connects microscopic particle motion to macroscopic electric current. It is a vector; its magnitude is often called the drift speed, although the two terms are sometimes used interchangeably.

Definition and physical meaning

Particles in a material can move rapidly without producing a net flow. At equilibrium, their velocity distribution is ordinarily symmetric: motion in one direction is balanced by motion in the opposite direction. An applied field can make that distribution slightly asymmetric, producing a nonzero average velocity.

For NN carriers of a particular species, the drift velocity can be expressed as

vd=⟨v⟩=1N∑i=1Nvi,\mathbf{v}_{\mathrm d} = \langle\mathbf v\rangle = \frac{1}{N}\sum_{i=1}^{N}\mathbf v_i,

where the velocities are measured relative to the material or surrounding medium. More generally, the average is taken over a local velocity distribution rather than over all particles in an entire sample.

The reference frame matters. An ion carried downstream by a moving liquid has both the liquid’s bulk velocity and a possible drift velocity relative to the liquid. Electrical transport normally distinguishes this relative drift from the bulk motion of the medium.

Drift velocity is not the same as the average speed of individual particles. The average velocity may be zero even when the average speed is large. In metals, electron speeds associated with Fermi energy are typically many orders of magnitude greater than the small drift speed required to carry an ordinary current.

Relation to electric current

For a single carrier species, the current density is

J=nqvd,\mathbf J=nq\mathbf v_{\mathrm d},

where nn is the carrier number density and qq is the signed charge of each carrier. This relation describes the charge transported per unit area per unit time.

For uniform flow normal to a conductor’s cross section,

I=nqAvd,I=nqAv_{\mathrm d},

with signed quantities taken along a chosen axis. In terms of magnitudes,

∣vd∣=∣I∣n∣q∣A.|v_{\mathrm d}|=\frac{|I|}{n|q|A}.

Here II is the current and AA is the cross-sectional area. If several species carry current, their contributions add:

J=∑snsqsvd,s.\mathbf J=\sum_s n_s q_s\mathbf v_{\mathrm d,s}.

Because electrons have negative charge, their drift direction is opposite to conventional current. Positive ions drift in the direction of the electric field, whereas negative ions drift against it. Both can therefore contribute current in the same conventional direction.

Example: a metallic wire

Using a representative conduction-electron density for copper of approximately 8.5×1028 m−38.5\times10^{28}\ \mathrm{m^{-3}}, a current of 1 A1\ \mathrm A through a wire with cross-sectional area 1 mm21\ \mathrm{mm^2} gives

∣vd∣=1(8.5×1028)(1.602×10−19)(10−6)≈7.3×10−5 m s−1.|v_{\mathrm d}| = \frac{1} {(8.5\times10^{28})(1.602\times10^{-19})(10^{-6})} \approx 7.3\times10^{-5}\ \mathrm{m\,s^{-1}}.

This is about 0.0730.073 millimetres per second. The value depends on the material’s carrier density and on the current per unit area.

Microscopic origin and the Drude model

An electric field exerts a force

F=qE\mathbf F=q\mathbf E

on a carrier. Without a mechanism for momentum relaxation, this force would continuously change the carrier’s momentum rather than establish a steady drift velocity.

In real materials, scattering processes involving lattice vibrations, impurities, defects, and other carriers affect transport. Scattering that transfers momentum to the lattice or otherwise relaxes the current allows a steady state to develop. Energy supplied by the field is ultimately transferred to the surroundings, producing Joule heating.

The classical Drude model, introduced by Paul Drude in 1900, represents momentum relaxation through a characteristic time τ\tau:

mdvddt=qE−mvdτ.m\frac{d\mathbf v_{\mathrm d}}{dt} = q\mathbf E-\frac{m\mathbf v_{\mathrm d}}{\tau}.

For a constant field and an initially zero mean velocity,

vd(t)=qτmE(1−e−t/τ).\mathbf v_{\mathrm d}(t) = \frac{q\tau}{m}\mathbf E \left(1-e^{-t/\tau}\right).

The steady-state result is

vd=qτmE.\mathbf v_{\mathrm d}=\frac{q\tau}{m}\mathbf E.

For electrons, q=−eq=-e, where ee is the positive elementary charge, so the drift is opposite to the field.

The relaxation time in this equation characterizes the decay of directed momentum; it need not equal the mean interval between every microscopic collision. Modern transport theories incorporate quantum mechanics and electronic band structure, but the relaxation-time picture remains useful in many regimes.

Mobility and conductivity

In the low-field, isotropic regime, carrier mobility μ\mu is conventionally defined as a positive quantity relating drift speed to electric-field magnitude:

∣vd∣=μ∣E∣.|v_{\mathrm d}|=\mu|\mathbf E|.

For positive and negative carriers, respectively,

vd,+=μ+E,vd,−=−μ−E.\mathbf v_{\mathrm d,+}=\mu_+\mathbf E, \qquad \mathbf v_{\mathrm d,-}=-\mu_-\mathbf E.

In the simple Drude model,

μ=∣q∣τm.\mu=\frac{|q|\tau}{m}.

Combining mobility with the current-density relation gives

J=σE,σ=n∣q∣μ,\mathbf J=\sigma\mathbf E, \qquad \sigma=n|q|\mu,

where σ\sigma is the electrical conductivity. This is the local form of Ohm’s law for a single carrier species in an isotropic material.

Mobility depends on the material, temperature, impurity content, and relevant scattering mechanisms. In crystals with direction-dependent transport, mobility and conductivity are generally tensors rather than single scalar values.

Drift and diffusion

Drift and diffusion describe different contributions to particle transport:

  • Drift is directed transport driven by an applied influence, such as an electric field.
  • Diffusion is transport associated with spatial variations in particle concentration.

A simple particle-flux equation for a dilute species is

Γ=nvd−D∇n,\boldsymbol{\Gamma} = n\mathbf v_{\mathrm d}-D\nabla n,

where Γ\boldsymbol{\Gamma} is particle flux and DD is the diffusion coefficient. The corresponding charge-current density is qΓq\boldsymbol{\Gamma}.

For dilute, nondegenerate carriers near thermal equilibrium, mobility and diffusion are related by

D=μkBT∣q∣,D=\frac{\mu k_{\mathrm B}T}{|q|},

where kBk_{\mathrm B} is the Boltzmann constant and TT is absolute temperature. This familiar relation requires modification for degenerate carrier populations and some nonequilibrium systems.

Drift and diffusion can oppose one another. A system may therefore have zero net particle flux even though both contributions are individually nonzero.

Different transport regimes

Semiconductors

In a semiconductor, both electrons and holes may carry current. In the low-field isotropic approximation,

σ=e(nμn+pμp),\sigma=e(n\mu_n+p\mu_p),

where nn and pp are electron and hole number densities. Holes behave as positively charged carriers and drift along the field.

At high fields, drift speed need not remain proportional to field strength. Increased scattering can lead to velocity saturation. Some semiconductors also exhibit ranges in which drift speed decreases as the field increases, so a constant-mobility description is inadequate.

Electrolytes and gases

In an electrolyte, positive and negative ions drift through a solvent. Their mobilities depend on interactions with the solvent and surrounding ions, not simply on their bare masses.

In gases, electron and ion drift depends on collisions with gas molecules and on the field relative to gas number density. These properties are important in ion-mobility measurements and particle detectors.

Magnetic fields and plasmas

A magnetic field changes carrier trajectories through the Lorentz force:

F=q(E+v×B).\mathbf F=q(\mathbf E+\mathbf v\times\mathbf B).

Consequently, the mean velocity need not be parallel or antiparallel to the electric field.

In magnetized plasmas, “drift velocity” also refers to the averaged motion of particle guiding centres. One example is the electric-field drift,

vE×B=E×BB2,\mathbf v_{E\times B} = \frac{\mathbf E\times\mathbf B}{B^2},

under appropriate slowly varying, magnetized conditions. This component is independent of particle charge and mass and occurs in the same direction for electrons and positive ions. It is distinct from ordinary collision-limited drift along an electric field.

Drift velocity versus signal propagation

The small drift speed in a wire does not imply that an electrical signal travels equally slowly. Signal propagation involves changes in electromagnetic fields throughout a circuit, not the transit of individual electrons from the power source to the load.

The propagation speed depends on the circuit geometry and surrounding materials and is often a substantial fraction of the speed of light. Charge carriers already present along the conductor respond to the arriving field disturbance.

With alternating current, carriers can move back and forth with little or no net displacement over a complete cycle while still transmitting energy. Their drift velocity varies with time and, at sufficiently high frequencies, need not remain in phase with the local electric field.

Applicability and limitations

Drift velocity is a statistical transport quantity, not a complete description of an individual particle’s trajectory. A local average is most useful when enough carriers are present and the averaging scale is compatible with the material’s microscopic dynamics.

In very short devices, carriers may cross the active region with little scattering, making a local steady-state mobility model inadequate. Rapidly varying fields, strong nonequilibrium conditions, and quantum-coherent transport may likewise require a velocity distribution or a more detailed transport theory rather than a single drift-velocity relation.